How to Get a Hub and Spoke to Dual Adapters

Step 1.
Take a Plug Tap and two Plug’s in correct phase.
Wire them together.
(Notice the RED goes to the RED and the GREEN goes to the GREEN.)

Step 2.
Insert the Plug Tap into a outlet strip or surge protector strip.
You may want to check to see if you have neutral or hot wires coming out of the strip or surge protector.
If your in a outlet strip then the Neutral and Ground (Neutral) are going to be one set of wires and the hot wires another set. If you find the above to be true then insert a plug on each set of wires coming from the first two outlets. If you find that the Neutral and Ground are separate

Step 3.
Add two more outlets on a another outlet strip and run the separate Neutral and Ground wires to the next strip.
Now use the Unused hot

Step 4.
Now you should have outlets on each outlet strip.
Now take the other two plugs in correct phase and see if they will fit your wall adapters.
if so then use the you just made a removable plug. If not then go to step 5

Step 5.
Cut or trim the plugs in the center so that they will fit the wall outlets.
(Warning.
If you cut them to short it may be a fire hazard.)

Step 6.
Take this newly created plug and Plug it into the first outlet on the first strip.
Take the other end and plug it into a wall plug that is on the outside of the home.

Step 7.
Run the power into Hub from the second outlet on the outside of the house.
Use a power cord or good CAT5 cable to run outlets inside the house.

Step 8.
Do the same for other hub and spoke modules.
( Notice the RED goes to the RED and GREEN goes to the GREEN.)

Step 9.
Install 1 Hub in the center of the house and install hub and spoke modules along the way to the outside.